We offer a wide range of bespoke training courses which are outlined below.
A bespoke course is tailored to your individual needs & requirements and can be run from a KOREC office or other mutually agreed venue.
To find out more about availability & content of these courses, please get in touch with us, using the details below;
Training on the configuration of data collection forms and management of mapping data, through to the management and operation of both the field (K-MOBILE) and office (K-PORTAL) systems.
Learn how to configure, maintain, operate and fly the senseFly eBee X, eBee Classic or eBee Plus. Training also available on the Parrot ANAFI.
A course which provides general GNSS technical theory, with the practice of taking and process GNSS observations for the installation of control networks. With the extension to RTK and Network RTK survey practice.
Understand the theory behind a site calibration in addition to the practice of observing the control and interpreting the results. A site calibration is required to operate GNSS equipment in a local grid coordinate system.
Trimble Access is used to guide delegates through the process of transferring setting out data onto a field controller and practicing common setting out procedures for the installation of point and line features.
An introduction to the setup and operation of a Trimble Total Station for common survey and setting out operations.
An introduction to the setup and operation of a Trimble GNSS system for RTK or Network RTK for survey and setting out operations.
Utilise the Road corridor functionality availability within Trimble Access Roads to set out and check road design data. Data sources include GENIO, LandXML and Trimble Road files.
Training covers the configuration and operation of both the field components and the T4D software the capture and reporting of monitoring data.
Scan data import, registration, clean up, deliverable generation and data export are all covered in this course.
Learn how to survey rail track using the GEDO system with Rec software for survey and Track software for pre and post tamp checks to alignment data.
A course that delivers practice of pre and post tamp surveys using the twin Track Measurement Device solution that is GEDO Vorsys.
Learn how to capture and process scan data captured using the GEDO Scan system. The course covers use of the software for clash detection and creation of ClearRoute SCO files.
A one-day course which covers the rapid survey of track using the GEDO IMS system and data post processing in GEDO Office.
Learn how to use Trimble Business Center to import rail design data from LandXML files and create alignments and surfaces in Trimble Machine Control ready formats.